DRIVE SYSTEM
7-94
Rev. 000
TX525 Service Manual
Tensioner Arm Wheel Bearing Installation -
Wide Track
Tension Arm Wheel and Bearings (Fig. 1610):
3. Turn the wheel over in the vice. Drive a second
bearing into the wheel bore with the longer flange of
the bearing facing inward (Fig. 1612).
Fig 1610
PICT-4517a
Fig 1612
PICT-4519
To install the inner tensioner wheel, continue on. To
install the outer tensioner wheel, go to step 16.
4. The loader arms should be to be raised approxi-
mately 12” (30.4cm).
5. With the bottom side facing up, slide the tensioner
arm far enough into the mainframe so that the
squared portion of the tensioner arm is inserted into
the mainframe (Fig. 1613).
1. Install the tensioner arm wheel into a vise to secure.
2. Press a bearing into the wheel bore with the longer
flange of the bearing facing inward (Fig. 1611).
Fig 1613
PICT-4578
Fig 1611
PICT-4518a
Summary of Contents for Dingo TX 525
