DRIVE SYSTEM
7-70
Rev. 000
TX525 Service Manual
3. Ensure old grease and dirt are cleaned out of the
area between the two washers and the bearings on
the outside tensioner wheel. Fill the area on one side
of the wheel with grease (Fig. 1525).
Fig 1525
PICT-4497
4. Install the large washer onto the wheel over the
grease (Fig. 1526).
Fig 1526
PICT-4498
Wide Track Installation
Important: Before installing the track, use the
Alignment Tool, Toro P/N 110-0069, for proper
alignment between the drive sprocket and the
front tension wheel. Refer to “Track Guide
Alignment” on page 7-3.
1. Install the track, ensuring that the lugs in the track
fit between the spacers in the middle of the drive
sprocket (Fig. 1523).
Fig 1523
PICT-4495
2. Install the track over the inside tensioner wheel (Fig.
1524).
Fig 1524
PICT-4496
Summary of Contents for Dingo TX 525
