Toro Dingo TX 525, Service Manual

Page: 235 / 554

ENGINE
4-182 Rev. 000 TX525 Service Manual
10. Remove the shaft assembly from the vise and clamp
the starter housing into the vise.
11. Slide the lever onto the shaft assembly between the
washer and the clutch (Fig. 0766).
Note: There is a notch in the bottom of the bearing
assembly (Fig. 0768) that fits into the groove
inside the housing (Fig. 0769). The notch
and groove must be lined up to fully seat the
bearing assembly in the housing.
Fig 0766 PICT-8112a
Fig 0768 PICT-8116
12. Insert the shaft/lever assembly into the starter
housing (Fig. 0767).
Fig 0769 PICT-8115
Fig 0767
PICT-8114