Toro Dingo TX 525, Service Manual

Page: 191 / 554

ENGINE
4-138 Rev. 000 TX525 Service Manual
107. Fill the engine with oil per specifications.
108. Fill the radiator. Refer to “Checking, Adding &
Bleeding the Engine Coolant” on page 4-138.
109. Disengage the park brake and start the unit.
110. Adjust the throttle cable. Refer to “Throttle Cable
Adjustment” on page 4-142.
111. Purge air from the hydraulic system. Refer to
“Purging Air Procedure” on page 9-19. Check for
any leaks at the hydraulic fittings and hoses.
112. Disengage the cylinder lock and lower the loader
arms.
113. Close the hood.
106. Install the rear access panel (Fig. 0603).
Fig 0603 PICT-4505a
Checking, Adding & Bleeding the
Engine Coolant
1. Check the level of coolant in the expansion tank.
The coolant should be at or above the mark on the
tank (Fig. 0604).
Fig 0604 Coolant 001
If coolant level is low, complete the following steps:
Caution: Do not remove the coolant fill cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the coolant
fill cap is cool to the touch before removing
the coolant fill cap.