Toro Dingo TX 525, Service Manual

Page: 41 / 554

MAINTENANCE
3-18 Rev. 000 TX525 Service Manual
19. Fill the radiator. Refer to “Checking, Adding & Bleed-
ing the Engine Coolant” on page 4-138.
20. Clean the area around the filler neck of the hydraulic
tank.
21. Remove the cap from the filler neck.
22. Fill the hydraulic tank with of 10W-30 or 15W-40
detergent, diesel engine oil (API service CH-4 or
higher).
23. Start the engine and let it run for a few minutes.
24. Stop the engine.
25. Check the fluid level on the dipstick. The fluid level
should be between the marks on the dipstick.
26. Install the cap into the hydraulic tank filler neck.
27. Install the left and right hand side panels (Fig. 0049).
Fig 0049 PICT-4945
28. Remove the cylinder lock and lower the loader arms.
29. Close the hood.
30. Purge air from the hydraulic system. Refer to “Purg-
ing Air Procedure” on page 9-19.
Drain & Clean Fuel Tank
Drain the fuel filter/water separator before each use or
daily (Fig. 0050).
A. Fuel filter/water B. In-line fuel filter
separator
Fig 0050 PICT-8751
Fuel System
Draining the fuel tank
Service interval: Every 2 years.
Replacing the fuel filter/water separator
Service interval: Every 400 hours
1. Clean the area where the fuel filter/water separator
mounts.
2. Remove the fuel filter/water separator and clean the
mounting surface.
3. Lubricate the gasket on the new fuel filter/water
separator with clean oil.
4. Install the fuel filter/water separator by hand until the
gasket contacts the mounting surface, then rotate it
an additional 1/2 turn.
A
B