Tokyo Keiki KRG-10, User Manual

Page: 107 / 200

6-32
Selected item
*A wave height level may be rough estimation for parameter settings.
2) Writing parameter
After selecting required application, if you click "Next", the following window will be displayed.
Click "OK" to write the most suitable parameter depend on selected item to the device, then
application setting wizard will be finished.
Fig. 6.4.3 Writing confirm dialog
Clear Setting
Select when you clear application parameters.
Tank
Select when you measure in a tank.
Calm Surfaces
Select when the device is used on the calm surface.
(wave height less than 5mm)
Ruffled Surfaces
Select when the device is used on the surface with ruffles.
(wave height more than 5 mm)
Discharged water
Select when much turbulent ruffles occurred due to inlet of liquids. (exp.
more than 100 L/s from 5m height)
Agitators
Select when the device is used in the tank with the agitators.
Rapid Change
Select when the device is used to measure the rapid change of the
surface. (e.g. Tsunami detection)
Pipe
Select when the device is used with pipe.
User input parameter
- Antenna Type Antenna type
(2” pipe / 4” pipe)
- Bore Internal diameter of the pipe
(0.0m to 99999.0m)
Open Path
Select when the device is used for measurement of open path surface.
(e.g. River / Seawater level)
River / Seawater
Select when the device is used to measure the slow change of the
surface. (e.g. River / Seawater level)