Tokyo Keiki KRG-10, User Manual

Page: 153 / 200

6-78
(8) Setting HART variables (*It is supported by firmware version 1.6.1 or later)
To set HART variables, switch the operation mode in the measurement operation area to
"HART Variables". Click [Setting Items] --> "Read" button to read the assignment of HART
variables from the device. Then, click [Setting Items] --> "Write" button to write the assignment
of HART variables to the device.
Fig. 6.9.19 Setting HART variables
HART variables
- Primary Variable (PV): Setting item to be assigned to PV
(Level / Distance / Volume / Flow / Signal Amp.)
- Secondary Variable (SV): Setting item to be assigned to SV
(Level / Distance / Volume / Flow / Signal Amp. / Unused / Electronic
Temp. / Maximum Volume / Maximum Flow / Volume Ratio / Flow
Ratio / Elapsed Time from Start / Search Count / Elapsed Time from
Final Search / Margin of Sensitivity)
- Tertiary Variable (TV): Setting item to be assigned to TV
(Level / Distance / Volume / Flow / Signal Amp. / Unused / Electronic
Temp. / Maximum Volume / Maximum Flow / Volume Ratio / Flow
Ratio / Elapsed Time from Start / Search Count / Elapsed Time from
Final Search / Margin of Sensitivity)
- Quaternary Variable (QV): Setting item to be assigned to QV
(Level / Distance / Volume / Flow / Signal Amp. / Unused / Electronic
Temp. / Maximum Volume / Maximum Flow / Volume Ratio / Flow
Ratio / Elapsed Time from Start / Search Count / Elapsed Time from
Final Search / Margin of Sensitivity)
HART variables setting "Read" button
HART variables setting "Write" button