FUEL SYSTEM
3-25
1-/ 2-Cylinder
lnstallation
1. Check that the round boss on the carburetor mates with
the hole in the clamp.
2. Position the carburetor on the crankcase inlet and push
until fully seated. Make sure that the carburetor is vertical.
Tighten clamp securely.
3. Install carburetor cover
(2)
.
4. Attach fuel hose
(1)
.
5. Install motor cover and open fuel cock.
Adiustments
NOTE
An access hole in the motor cover allows idle
adjustment
with the motor cover on.
1. IDLE – With the throttle in the START position, turn the
slow stop screw aIl the way in, then back-out l-1/4 turns.
Start the engine and after warm-up, move the throttle all the way
down to the idle position. Turn the stop screw clockwise to
increase RPM, or counterclockwise to decrease RPM.
14
15
16
16
17
T1135
15
T1155
14
T1156
T1124
Summary of Contents for 2 Stroke Cylinder Series
