Thermador PRG486JDG/01, Service Manual, Page: 64 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 65 of 92
Figure 96: Using Access Holes for Removing Fan Screws
1 Screwdriver (shown through access hole)
5. Using gloves, remove the cooling fan.
6. Replace the cooling fan if needed.
6.9 Removal and Replacement of Front-Accessible
Components
This section contains removal and replacement procedures for the
components that can be accessed from the front of the range. Some
of these components also require additional access from the top of
the range (removal of maintop components), from the side of the
range, or from the back of the range.
6.9.1 Oven Temperature Sensor for Large and Small Ovens –
Removal and Replacement
For the oven temperature sensors, access is required from the
front and side of the range.
Before replacing the temperature, see Oven Temperature Sensor
Diagnostics, page 20.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22 .
2. Remove the right side panel (for the large oven), or remove the
left side panel (for the small oven). See Side Panel Removal and
Replacement, page 29.
3. Remove oven door (see Removing the Door, page 70).
4. Remove oven trays.
5. From inside the oven cavity, remove and retain the two screws on
the oven temperature sensor (see Figure 97).
Figure 97: Oven Temperature Sensor
6. At the right side of the range, disconnect the wire connector to the
sensor, and then pull the sensor inside the oven cavity.
7. Replace the sensor if necessary.