Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 10 of 92
m
Caution
Code Compliance
Local codes vary. Installation, electrical connections, gas connections,
and grounding must comply with all applicable codes.
2 OPERATION AND CONTROLS
2.1 Knobs and Controls
The control knobs each have an icon to identify the burner location.
2.1.1
Standard Burner Knob
1. Press a control knob in, and turn counter-clockwise to
HI
setting.
The igniter for the burner clicks while sparking until flame ignition.
Burner should ignite within 4 seconds.
2. For the standard burners, rotate the knob to any setting between
the three markers for
HI,
MED,
and
SIM
.
2.1.2
ExtraLow (XLO) and ExtraHi (XHI) Burner Knobs
XLO and XHI knobs can be set anywhere between the XLO and XHI
markings for a variable range of heat; from 105° F (for XLO) to 185° F
(for XHI).
The burners that have XLO functionality are:
•
Left, front
•
Left, rear
•
Right, front
•
Right, rear
The burner at the right, front has XHI functionality (in addition to XLO).
When in
XLO
mode - the very lowest flame setting, the flame cycles
on for approximately 8 seconds and then turns off for 52 seconds of
each minute.
■
Press a control knob in, and turn counter-clockwise to
HI
or
XHI
.
The igniter for the burner clicks while sparking until flame ignition.
Burner should ignite within 4 seconds.
2.1.3
Griddle / Grill Control Knob
The griddle / grill knob controls the temperature to the griddle or grill,
from 150° F to 500° F.
■
Press and turn the knob clockwise to select a setting.
NOTE:
The electric griddle preheat time (the time from when the
griddle is turned on until the preheat light goes off) will vary according
to ambient (room) temperature and the level of electrical service. To
preheat the griddle to 350° F may take approximately 10 to 14
minutes.
2.1.4
Temperature / Function Selector Knob for Large Oven
The Temperature/Function Selector Knob for the large oven enables
selecting a temperature from 150° F to 500° F, as well as one of the
oven function modes.
NOTE:
Warm setting displays “Warm’” which is about 150° to 175° F.
■
Rotate the outer dial to select a cooking mode, and then rotate the
inner knob to select the temperature.
TESTED IN ACCORDANCE WITH ANSI
Z21.1, THE STANDARD FOR HOUSEHOLD
COOKING GAS APPLIANCES. IN CANADA
TESTED IN ACCORDANCE WITH
CAN/CGA1.1 – M81, THE STANDARD FOR
DOMESTIC GAS RANGES.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.1/
NFPA 54 current issue and the National
Electrical Code ANSI/NFPA No. 70 current issue
or the Can – B149 Installation Codes for Gas
Burning Appliances and C22.1 Canadian
Electrical Code Part 1.
It is the responsibility of the owner and the
installer to determine if additional requirements
apply in specific installations.