Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 76 of 92
Figure 119: Broil Components at Back of Range
1
Insulation
2
Elbow connector (holds broil burner orifice)
3
HSI wire harness (wire connectors not shown)
4
Wire connector
6. From the back of the range, after making a note of which wires are
connected to each of the two HSI terminals, and then detach the
wire connectors from the HSI (see Figure 119).
NOTE:
It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
7. From inside of the range, use a 9 mm open end wrench to remove
and retain the two nuts with lock washers that secure the HSI
retaining bracket onto the broil burner studs and then detach the
HSI retaining bracket (see Figure 120).
8. Remove and retain the two screws and respective nuts with lock
washers that secure the HSI onto the HSI retaining bracket (see
Figure 118, page 75 and Figure 120).
9. Pull the HSI out of the retaining bracket.
10. See
on
page
and replace the
HSI if needed
.
Figure 120: HSI in HSI Retaining Bracket (Shown Installed)
1
HSI retaining bracket
2
Screw (2) and nut with lock washer (2) securing HSI
onto HSI retaining bracket
3
Nut with lock washer (2) securing HSI retaining
bracket onto broil burner