Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 60 of 92
Figure 87: Oven Light Switch Bezel
1
Light switch bezel
2
Screw for display module
3
Screw for display module
4. At the back side of the control panel, pull out the oven light switch.
Leave its two spade connectors attached unless you are going to
replace the light switch (see Figure 88).
5. If needed, replace oven light switch by detaching the two spade
connectors from its terminals (see Figure 88).
6. On the bottom side of the control panel under the display, remove
and retain the two display module screws (Figure 87).
7. At the back side of the control panel, detach the wire connector
from the display module.
8. Remove the display module by pulling it over the manifold.
9. Replace the display module if needed.
Figure 88: Removing Oven Light Switch from Display Module
6.8 Removal and Replacement of Back-Accessible
Components
This section contains removal and replacement procedures for the
components that can be accessed from the back of the range.
NOTE:
Before and after servicing the range from the back, refer to the
Installation Manual for instructions on moving the range, installing the
anti-tip bracket and other important installation and safety information.
Moving the Range
For servicing that requires access from the back of the range, it may
be necessary to move the range. Due to the immense weight of the
range, using an air dolly to move it may reduce the risk of injury
and/or damage. It is recommended to have more than one person to
move the appliance.