Thermador PRG486JDG/01, Service Manual, Page: 53 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 54 of 92
Figure 74: Detaching the Lighting Bar Wire Connector
Figure 75: Removing the Tape from the Lighting Bar
1 Location of tape securing lighting bar to control panel
2 Location of tape securing lighting bar to control panel
3 Location of tape securing lighting bar to control panel
6.7.18 Ignition (Spark) Module Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Figure 76: Ignition (Spark) Module
1 Screws (2)
2 Wire connectors (2)
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22 .
2. Follow all steps in Accessing Components under the Maintop ,
page 22 .
3. If obstructing access to the ignition module, remove the burner
support rail (with jet holder assemblies attached) by following the
steps in
Removing the Burner Support Rail, page 25.
4. Pull to detach the two side connectors from the ignition module
(see Figure 76).
5. Remove and retain the two screws securing the ignition module to
the range chassis (see Figure 76).
6.
Replace the ignition module if needed.