Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 89 of 92
Figure 144: Bottom Vent on Oven Door (Typical Door Shown)
1
Vent at the bottom of the oven door
m
Caution
Abrasive Materials
Do not use abrasive cleaners or materials, such as steel wool, as they
may scratch the glass
4. Insert a clean, non-abrasive wash cloth or rag into the bottom vent
to clean. You may need a flexible brush to reach the entire
surface. See Figure 144.
6.9.10 Oven Door Components – Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and correct part numbers when replacing any of these
components.
This procedure is applicable for both the large and small oven doors.
1. Follow all safety precautions and steps in
2. Remove door (see
Oven Door Removal, Installation, and
page
3. Place the door on a protective mat with the handle facing down.
4. Remove and retain the four screws from the base of the door
assembly (two from each side), as shown in Figure 145.
NOTE:
Do not remove the other four screws from the base of the
door assembly.