Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 58 of 92
Figure 82: Plunger Switch
Figure 83: Removing the Plunger Switch Bezel
6.7.21
Griddle / Grill Thermostat Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Figure 84: Typical Thermostat
m
Caution
When installing the thermostat, extend the capillary tube to the
needed length, however be careful not to twist or bend it, or it may
impede the component’s ability to operate properly.
1. Follow all safety precautions and steps in
2. Follow all steps in
Accessing Components under the Maintop
3. Remove and retain the two screws on the bezel of the thermostat
knob. These screws connect the thermostat to the back side of the
control panel.
4. Remove thermostat bulb from the retaining bracket in the griddle
tray, and then gently pull it through the receptacle (see
Griddle /
Grill Removal and Replacement
on page
27,
and Figure 85).
5. Remove the thermostat from the back of the control panel, and
replace it if needed.