Thermador PRG486JDG/01, Service Manual, Page: 42 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 43 of 92
6.7.8 Manifold for Bake and Broil Burners – Removal and
Replacement
For removing the bake and broil manifold, access is from the top and
back of the range. Be sure to check QuickFinder for relevant
information, documentation, and the correct part number when
replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 22.
2. Follow all steps in Accessing Components under the Maintop ,
page 22 .
3. Remove the backguard (see Backguard Removal and
Replacement, page 61) .
Figure 55: Large Flue Cover
1 Screws (2) securing large flue cover to the range
4. Remove the back panel(s). See Back Panel for Small Oven –
Removal and Replacement, page 62, and Back Panel for Large
Oven – Removal and Replacement, page 63.
5. At the back of the range, remove and retain the two screws
securing the large flue cover to the range chassis, and then
remove the flue cover (see Figure 55).
6. Use an adjustable wrench to loosen the compression nuts and
detach each of the gas tubes from the respective manifold fittings
(see Figure 56).
7. Detach the other ends of the gas tubes from the bi-metal gas
valves, and remove the gas tubes.
Figure 56: Gas Tubes and Compression Nuts (Shown Connected to
Manifold Fittings)
1 Compression nuts & respective manifold fittings (3)