Thermador PRG486JDG/01, Service Manual, Page: 52 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 53 of 92
5. While holding the two sides of a wire connector, rotate them to
detach (see Figure 72, page 52).
6. Push the protruding clip at the front end of the LED indicator while
you simultaneously push the LED indicator frontward through the
hole in the control panel (see Figure 73).
7. Replace the LED indicator if needed.
Figure 73: Removing the LED Indicator
6.7.17 Lighting Bar for Control Panel – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22 .
2. Follow all steps in Accessing Components under the Maintop ,
page 22.
3. Remove the control panel (see Control Panel Removal and
Replacement , page 32).
4. Remove the LED indicator retaining brackets (see LED Indicator
Removal and Replacement, page 52 ).
5. Detach the lighting bar wire connector (see Figure 74, page 54).
6. Use a flat-blade screwdriver to detach the lighting bar from the
tape that holds it onto the control panel. Tape is at the left, center,
and right locations on the lighting bar (see Figure 75, page 54).
NOTE: When installing a replacement lighting bar, be sure to affix
the tape at the same three locations.