Thermador PRG486JDG/01, Service Manual, Page: 71 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 72 of 92
6.9.4.3 Aligning the Door
On models that have an alignment mechanism as a part of the
hinge receiver, you can adjust the door alignment by rotating the
alignment screw that is located below each hinge / hinge receiver slot.
1. Make sure the door is installed correctly so it will not pose any
danger by falling while adjusting the screw (see Installing the
Door, page 71 ).
2. Locate the alignment screw below the door hinge (Figure 109).
3. Use a T-27 driver to turn the alignment screw until the door is
properly aligned.
Figure 109: Alignment Screw (Shown with Door Removed)
1 Slot for hinge
2 Hinge receiver screw
NOTE: Do not rotate the hinge receiver screw. It
is not used for door alignment.
3 Door alignment screw
6.9.5 Convection Components – Removal and Replacement
All convection components are accessed from the front of the
range.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 22 .
2. Remove oven door (see Oven Door Removal, Installation, and
Alignment, page 70).
3. Remove all the oven racks.
4. Remove and retain the screws from the front convection cover,
and then remove the front cover (see Figure 110).
Figure 110: Convection Cover