Thermador PRG486JDG/01, Service Manual, Page: 31 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 32 of 92
6.6 Control Panel Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 22.
2. Complete steps for Accessing Components under the Maintop,
page 22.
3. Remove only the rangetop burner knobs from the control panel.
4. At the bezels on the control panel, remove and retain the screws
that connect to the two manifold support brackets. These are
located at the second-from-left and second-from-right bezels (see
Figure 33).
Figure 33: Locations of Manifold Support Brackets
1 Location attached to manifold support bracket
2 Location attached to manifold support bracket
5. Remove both the right and left side panels (see Side Panel
Removal and Replacement, page 29 ).
6. Remove and retain the screws from underneath the control panel
(see Figure 34).
Figure 34: Removing Screws under the Control Panel
7. Remove the screws securing the control panel flange onto the top
of the front crossmember (located behind the control panel). See
Figure 35.
Figure 35: Removing Control Panel Screw Attaching Control Panel
Flange onto Front Crossmember