Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 35 of 92
Figure 39: Wire Guard Clip (Shown Removed)
5. Use a flat-bladed screwdriver to pry the jet holder assembly out
until the alignment boss is disengaged from the circular receptacle
on the burner support rail. Simultaneously rotate the jet holder
assembly counter-clockwise (gloves recommended) until it can be
removed through the corresponding grooves in the burner support
rail. You may need a crescent wrench to assist in rotating the jet
assembly (see Figure 40 and Figure 41).
6. Replace the jet holder assembly if needed.
NOTE:
If replacing the jet holder assembly, first install the jet
holder assembly onto the burner support rail before attaching the
wire guard clip.
Gas Leaks
Carefully check for gas leaks at each gas component that was
removed, replaced, or otherwise serviced using a gas leak
detector (electronic leak detectors are highly recommended) or
bubble test.
Figure 40: Removing Jet Holder Assembly
Figure 41: Alignment Boss (Shown from Below Burner Support Rail)
1
Alignment boss