Thermador PRG486JDG/01, Service Manual, Page: 62 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 63 of 92
6.8.3 Back Panel for Large Oven – Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22 .
2. Remove the backguard, per Backguard Removal and
Replacement procedure, page 61.
3. Detach the power cord wires from the terminal block, and remove
the power cord.
4. Remove and retain the eight screws from the back panel, and
then remove the back panel (see Figure 92, page 62).
5. Replace the back panel if needed.
6.8.4 Terminal Block and Power Cord – Removal and
Replacement
At the terminal box (junction box), replace the terminal block in
the event the terminal threads are stripped, or if there is any other
damage to the component. The power cord is also replaced at the
terminal box.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 93: Terminal Block Positioned In the Terminal Box
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 22 .
2. Detach all wire leads from each terminal on the terminal block and
from the grounding screw (see Figure 93). Retain all nuts,
washers / lockwashers and grounding screw, and make a note of
all the wire connections.
3. If replacing the power cord, after detaching the wires from the
terminal block, pull the cord out from the terminal box.
4. Remove and retain the two screws that secure the terminal block
onto the terminal box.
5. Replace the terminal block if needed.