Themis RES-32DCX, Installation Manual

Page: 54 / 146

Installation and Operation
Installation Procedures
2-5
Themis Computer
3. If a module is already seated in the slot you have selected for installation,
remove it by gently pressing down and outward on the latches at both ends of
the slot (see
Figure 2-3 ), then pulling the old module directly up from the slot
until it is free of the connector.
4. Before inserting a new memory module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new module verti-
cally into its slot and press firmly downward until it snaps into place.
Figure 2-3. Memory Module Removal
downward &
outward at
each end
Press latch
Note: Make sure the memory module has the proper orientation by align-
ing the alignment notch at the bottom edge with its counterpart ridge at
the bottom of the slot.