Themis RES-32DCX, Installation Manual

Page: 64 / 146

Installation and Operation
Rack Mounts
2-15
Themis Computer
2.2 Rack Mounts
2.2.1 Mounting Brackets
Two types of rack-mount brackets (flanges) can be ordered for the RES-32DCX to
secure the chassis to the 19” rack: brackets with handles (see
A , Figure 2-11 ), and
brackets without handles (see B , Figure 2-11 ). The chassis contains three threaded
screw holes on each side to accommodate #10-32 size screws (included with the
bracket package).
Brackets with handles are used to pull the RES-32DCX from the rack when rack-
mount slides have been installed on the sides of the chassis (see following section).
2.2.2 Rack-Mount Slides (Optional)
Rack-Mount Slides can be mounted on each side of the RES-32DCX, for the pur-
pose of sliding the unit in and out of a rack. Mounting slides are optional and should
be ordered at the time your system is purchased.
To learn how to install rack-mount slides, refer to Appendix B, “Rack-Mount Slide
Installation”.
Figure 2-11.
Rack-Mount Bracket with ( A ) and without a Handle ( B )
A B
Caution: Any screws used to mount a slide to a RES-32DCX chassis must not ex-
ceed a length of 3/8” to prevent excessive penetration of the chassis.