2-7
Themis Computer
Installation and Operation
Installation Procedures
2.1.3.2 Disk-Drive Removal
To remove a hard-disk drive,
1.
Make sure the system is powered off (see “Operation” on page 2-16).
2.
Locate the drive to be removed (see
A
in
Figure 2-5
).
3.
Place a finger into the latch lock and push to the side; this causes the drive
latch handle to spring forward (see
B
) from the front surface of the drive.
4.
Carefully pull the latch handle (see
C
) until the drive has cleared the chassis.
The drive will automatically disconnect from its backplane connector when
pulled forward.
Caution:
When pulling the hard-disk drive from the chassis, hold it at the
bottom to prevent it from falling and damaging the drive.
Figure 2-5.
RES-32DCX Hard-Disk Drive Removal
Locate the drive to be removed, . . .
A
. . . push the latch lock to the side, . . .
B
Latch
Lock
Latch Handle
. . . and pull drive out with the latch handle
C
Summary of Contents for RES-32DCX
