Themis RES-32DCX, Installation Manual

Page: 61 / 146

2-12
Themis Computer
RES-32DCX Installation Manual
2.1.6 Power Supply
Each 460-watt load-sharing (N+1 redundant) power supply can be hot-swapped
while the system is still on and operational.
2.1.6.1 Removing a Power Supply
Perform the following steps to remove a power supply:
1. To remove a power supply, first loosen and remove the two captive screws
holding the power supply handle retainer (see
A , Figure 2-9 ).
2. Loosen and remove the two captive screws holding the power-cord bracket.
3. Hook your right index finger into the extraction handle and pull the locking
lever to the right with the right thumb (see
B , Figure 2-9 ), freeing the power
supply from being held within the chassis.
4. Pull the power supply until it is free of the chassis.
Caution: When pulling the power supply from the chassis, hold it at the bot-
tom to prevent it from falling and damaging the unit.
Figure 2-9.
The RES-32DCX Power Supply Locking Mechanism
Extraction
Power Supply
Captive
Captive
Push right to release power supply
Power-Cord
Handle Retainer
Locking
A
B
Screw (2)
Bracket
Handle
Screw (2)
Lever