Themis RES-32DCX, Installation Manual

Page: 38 / 146

1-9
Themis Computer
Overview and Specifications
Overview
1.1.2.1 Suspend-State Indicator
When the CPU enters a suspend state, the
Power
LED will start blinking to indicate
that the CPU is in suspend mode. Pressing any key on the keyboard will awaken the
CPU, at which time the power LED will stop blinking and remain on.
1.1.2.2 Main Switch Override
ATX 2.01 (or higher)-compliant power supply only. If enabled in the system setup,
the RES-32DCX power button on the front of the unit functions as a suspend button
to make the system enter a SoftOff state. The monitor is suspended, and the hard
drive will spin down. Pressing the power button again will cause the system to
awaken.
During the
SoftOff
state, the ATX power supply provides only enough power to
keep the minimum required circuitry alive. If you want to turn the power off com-
pletely, in the event of a system malfunction, for example, depress and hold the
power button for four (4) seconds. The system will turn off completely with no
power to the motherboard provided. This option can be set in the Power section of
the BIOS setup routine.
1.1.2.3 External Modem Ring-On
ATX 2.01 (or higher)-compliant power supply only. When the system is in the
SoftOff
state, it can be awakened by the ringing of an external modem. This fea-
ture can only be provided if “External Modem Ring-On” is included in the installed
modem card and the corresponding setting is enabled in the system BIOS settings.
1.1.2.4 Wake-On-LAN (WOL)
ATX 2.01-compliant (or higher) power supply only . The
Wake-On-LAN
utility
enables a management application to remotely power up a computer that has been
powered off. This allows remote PC setup, updates and access tracking to occur
after hours and on weekends, so that daily LAN traffic is kept to a minimum and
users are uninterrupted. The serverboard employs a 3-pin header (JWOL) to connect
to the 3-pin header of any Network Interface Card (NIC) with WOL capability.
Wake-On-LAN must be enabled in BIOS.