Teledyne T3DSO1000, User Manual, Page: 223 / 227

User Manual 205
AUSTRALIA & NEW ZEALAND DECLARATION OF CONFORMITY – EMC
The instrument complies with the EMC provision of the Radio Communications Act per the
following standards, in accordance with requirements imposed by Australian Communication and
Media Authority (ACMA):
AS/NZS CISPR 11:2015 Radiated and Conducted Emissions, Group 1, Class A.
Australia / New Zealand Contacts:*
RS Components Pty Ltd. RS Components Ltd.
Suite 326 The Parade West Units 30 & 31 Warehouse World
Kent Town, South Australia 5067 761 Great South Road
Penrose, Auckland, New Zealand
* Visit teledynelecroy.com/support/contact for the latest contact information.
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The instrument meets intent of EC Directive 2014/35/EU for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use –
Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control,
and laboratory use –
Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
• Mains Supply Connector: Overvoltage Category II, instrument intended to be supplied from the
building wiring at utilization points (socket outlets and similar).
• Measuring Circuit Terminals: No rated measurement category. Terminals not intended to be
connected directly to the mains supply.
• Unit: Pollution Degree 2, operating environment where normally only dry, non-conductive
pollution occurs. Temporary conductivity caused by condensation should be expected.
THIRD PARTY AGENCY CERTIFICATION
The instrument has been certified by TUV SUD product Services GmbH for all the applicable
European Union (EU) safety requirements per IEC 61010-1 and IEC 61010-2-030 standards.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
As an accredited National Recognized Testing Laboratory (NRTL), TUV SUD Product Services
GmbH has certified the instrument to meet all the applicable US safety standards. The
instrument is marked with the TUV SUD NRTL mark for U.S.