Teledyne T3DSO1000, User Manual, Page: 103 / 227

User Manual 85
On the 17th Clock Edge
Read
●
7 Bit Address & Data — the oscilloscope will be triggered when the
following conditions are satisfied.
➢
The address’s length must be 7 bits and the address’s value is the same as
the address trigger value.
➢
If you have set either Data1’s or Data2’s value, and the signal has data that
is the same as that value. If you have set both Data1’s and Data2’s value,
the signal should have two consecutive data values, the first data value is
Data1, second data value is Data2.
( Note : If the data value is 0xXX, any data value will be matched)
On the 26th Clock Edge