Teledyne T3DSO1000, User Manual, Page: 128 / 227

110 User Manual
LIN Triggering
This part will provide a brief introduction and description for the operation of the LIN
trigger.
The possible trigger conditions
●
Break — The oscilloscope will be triggered at the position of break field’s break
delimiter.
●
ID (Frame ID) — the oscilloscope will be triggered at the position of the identifier
field’s stop bit, if the value of a frame’s ID is equal to specified value.
(Note: If the data’s value is 0xXX, any data value will be matched)
●
ID + Data (Frame ID and Data) — the oscilloscope triggers when a frame with an
ID and data equal to the selected values is detected. Use the Universal Knob to
select the value for the ID, Data1 and Data2.
1) The ID’s value is the same as the value currently set.
2) If you have set either Data1’s or Data2’s value, and the signal has data that
matches that value. If you have set both Data1’s and Data2’s value, the signal
should has two consecutive data, the first data’s value is Data1, the second data
value is Data2.
( Note : If the data’s value is 0xXX, any data value will be matched)
●
Data Error —the oscilloscope will be triggered when errors (such as ID check
error, checksum error, sync byte field error) are detected.
Operation steps:
1. Press Setup to enter the TRIGGER function menu.
2. Press Type and select Serial .
3. Press Protocol and select LIN .
4. Press Trigger Setting softkey to enter LIN TRIG SET menu.