Teledyne T3DSO1000, User Manual, Page: 104 / 227

86 User Manual
●
10 Bit Address & Data — the oscilloscope will be triggered when the
following conditions are satisfied.
➢
The address’s length must be 10 bits and the address’s value is the same as
the address set value.
➢
If you have set either Data1’s or Data2’s value, and the signal has data that
is the same as those values in that order.
( Note : If the set value is 0xXX, any data value will be matched)
Write
●
Data Length — When SDA data’s length is equal to the value of Byte Length and
address’s length is the same as the set value, the oscilloscope will be triggered.
Byte length is in the range of 1 to 12 bits.
Operation steps:
1. Press Setup to enter the TRIGGER function menu.
2. Press Type and select Serial .
3. Press Protocol and select I2C .
4. Press Trigger Setting softkey.