Teledyne T300, Operation Manual, Page: 120 / 426

Setup Menu Teledyne API – Model T300/T300M CO Analyzer
118
5.9.1. SIGNAL I/O
The signal I/O diagnostic mode allows a user to review and change the digital and
analog input/output functions of the analyzer. Refer to Appendix A-4 for a full list of
the parameters available for review under this menu.
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Any changes of signal I/O settings will remain in effect only until the
signal I/O menu is exited. Exceptions are the ozone generator override
and the flow sensor calibration, which remain as entered when exiting.
Access the SIGNAL I/O test mode from the DIAG Menu:
SAMPLE RANGE=50.0 PPM CO= XXXX
<TST TST> CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
EXAMPLE
DIAG I/O 0) EXT_ZERO_CAL=OFF
PREV NEXT EDIT PRNT EXIT
Press PREV and
NEXT to cycle through
the signal types.
DIAG I/O 1)EXT_SPAN_CAL=OFF
PREV NEXT JUMP EDIT PRNT EXIT
Press JUMP to go
directly to a specific
signal
(see Appendix A for a list
of all I/O SIGNALS )
DIAG I/O JUMPTO: 0
0 0 JUMP ENTR EXIT
Toggle to set
location No. of the
signal to JUMP to.
DIAG I/O JUMPTO: 22
2 2 JUMP ENTR EXIT
DIAG I/O 22) RELAY_WATCHDOG=ON
PREV NEXT JUMP OFF PRNT EXIT
Pressing PRNT will send a formatted
printout to the serial port and can be
captured with a computer or other
output device.
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
DIAG SIGNAL I/O
NEXT ENTR EXIT
On status signals this
button toggles the
signal ON / OFF.
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
06864B DCN6314