Tektronix RSA3408B, Service Manual

Page: 158 / 250

Removal and Installation Procedures
5- 30
RSA3408B Analyzer Service Manual
1. Assemble equipment and locate module to be removed:
a. You will need a #2 Phillips screwdriver.
b. Locate the RF5 module in the locator diagram RF Modules , Figure 5--3
on page 5--13.
2.
Orient the analyzer:
Set the analyzer so the bottom is down on the work
surface and its front is facing you.
3.
Remove the RF5 module: See Figure 5--15. Also see Figure 5--37 on
page 5--75 for the cable interconnection.
a.
Unplug the following SMB cables on the RF5 module:
W207, W31, W30, W29, W208, W32, W41, and W40.
b. Remove the two screws securing the module to the main chassis.
Lift the module up.
4.
Reinstallation: Reverse step 3 to reinstall the RF5 module.
1. Assemble equipment and locate module to be removed:
a. You will need a #2 Phillips screwdriver.
b. Locate the RF6 module in the locator diagram RF Modules , Figure 5--3
on page 5--13.
2. Orient the analyzer: Set the analyzer so the bottom is down on the work
surface and its front is facing you.
3.
Remove the RF6 module:
See Figure 5--15. Also see Figure 5--37 on
page 5--75 for the cable interconnection.
a.
Unplug the following SMB cables on the RF6 module:
10 MHz REF IN and OUT, W32, W503, W29, W611, W502, and W610.
b. Remove the two screws securing the module to the main chassis.
Lift the module up.
4.
Reinstallation:
Reverse step 3 to reinstall the RF5 module.
RF5 Module
RF6 Module