Tektronix RSA3408B, Service Manual

Page: 135 / 250

RSA3408B Analyzer Service Manual
5- 7
Removal and Installation Procedures
This subsection contains procedures for removal and installation of all mechani-
cal and electrical modules. Any electrical or mechanical assembly, or part listed
in Section 10 of this manual is a module.
Preparation
WARNING.
Before doing this or any other procedure in this manual, read the
Safety Summary found at the beginning of this manual. Also, to prevent possible
injury to service personnel or damage to this analyzer’s components, read
Installation in Section 2, and Preventing ESD in this section.
This subsection contains the following items:
H
This preparatory information that you need to properly do the procedures
that follow.
H
List of tools required to remove and disassemble all modules.
H
Nine module locator diagrams for finding the External modules (see
Figure 5--2), RF modules (see Figure 5--3), CPU board and disk modules
(see Figure 5--4), Removable hard disk modules (Option 06 only, see
Figure 5--5), Motherboard and daughterboards (see Figure 5--6), Bottom
modules -- Power supply (see Figure 5--7), Bottom modules -- RF1 (see
Figure 5--8), Front panel modules (see Figure 5--9), and Chassis modules
(see Figure 5--10) in this analyzer.
H
Procedures for removal and reinstallation of the electrical and mechanical
modules.
H
A disassembly procedure for removal of all the major modules from the
analyzer at one time and for reassembly of those modules into the analyzer.
Such a complete disassembly is normally only done when completely
cleaning the analyzer. (Cleaning instructions are found under Inspection and
Cleaning at the beginning of this section.)
WARNING.
Before doing any procedure in this subsection, disconnect the power
cord from the line voltage source. Failure to do so could cause serious injury or
death.