Tektronix RSA3408B, Service Manual

Page: 50 / 250

Performance Tests
3- 18
RSA3408B Analyzer Service Manual
4. Perform the tests in the baseband and RF1 band:
Press the
BB+RF1
side key to perform the tests.
5.
Check the test results:
Check the pass/fail results displayed on the lower left of the screen
(see Figure 3--7 on page 3--16).
If the instrument fails any tests, go to When the Auto Tests Fail on
page 3--19.
6.
Change the signal generator:
a. Disconnect the N--N cable from the signal generator (Item 1) output.
b. Connect the N--N cable to the signal generator (Item 2) output.
c. Set the GPIB address of the generator:
H
Press the Config... side key.
H
Press the SG Type side key to select the manufacturer of the
generator (Item 2) for the GPIB command system: HP or Anritsu.
H
Press the GPIB Address side key and set the generator address.
H
Press the Cancel--Back (top) side key.
7. Perform the tests in the RF2 and RF3 bands:
Press the RF2+RF3 side key to perform the tests.
8. Check the test results:
Check the pass/fail results displayed on the lower left of the screen
(see Figure 3--7 on page 3--16).
If the instrument fails any tests, go to When the Auto Tests Fail on
page 3--19.
9.
Disconnect the test equipment:
a. Disconnect the N-N cable from the analyzer input.
b. Turn off the analyzer and generators.
c. Disconnect the GPIB cables from all the ports.