Tektronix RSA3408B, Service Manual

Page: 193 / 250

Removal and Installation Procedures
RSA3408B Analyzer Service Manual
5- 65
3. Remove the board guide bracket: Remove the four screws securing the board
guide bracket to the main chassis. Lift the bracket up and away.
4.
Remove the PC board guide bracket:
Remove the two screws securing the
PC board guide bracket to the main chassis. Lift the bracket up and away.
5.
Reinstallation: Reverse steps 3 and 4 to reinstall the board guide brackets.
1.
Assemble equipment and locate module to be removed:
a. You will need a screwdriver with #1 and #2 Phillips tips (Items 1, 2 and
3) and a flat-bladed screwdriver (Item 5).
b.
Locate the rear panel in the Chassis modules diagram, Figure 5--10 on
page 5--20.
2. Orient the analyzer: Set the analyzer so its bottom is down on the work
surface and its rear is facing you.
3.
Remove the SMB-BNC connector:
See Figure 5--33.
a. Unplug the coaxial cable from the connector.
b. Using a #1 Phillips screwdriver, remove the four screws securing the
connector to the rear chassis. Pull the connector away.
SMB -- BNC connector
Rear panel
GPIB connector
SMB cable
Figure 5- 33: Rear panel removal
Rear Panel