Tektronix RSA3408B, Service Manual

Page: 138 / 250

Removal and Installation Procedures
5- 10
RSA3408B Analyzer Service Manual
Equipment Required. Most modules in this analyzer can be removed with a
screwdriver with a size #2, Phillips tip. Use this tool whenever a procedure step
instructs you to remove or install a screw unless a different size screwdriver is
specified in that step.
All equipment required to remove and reinstall a module
are listed in the first step of each procedure.
Table 5- 5: Tools required for module removal
Item
No. Name Description
Tektronix
part number
1 Screwdriver handle Accepts
1
@
4
inch hex-head driver tips
2 #1 Phillips tip Phillips-driver bit for #1 size screw
heads
3 #2 Phillips tip Phillips-driver bit for #2 size screw
heads
4 No. 2 Pozidriv tip Pozidriv-driver bit for number 2 size
screw heads
5 Flat-bladed screwdriver Screwdriver for removing standard-
headed screws
6 SMA torque driver Accepts SMA hex-head driver bits 003-1423-91
7 Long type bit Long type bit (H 8 mm
×
L 130 mm)
for SMA/3.5 mm connector
003-1422-00
8 Nutdriver, 12 mm Standard tool
9 Nutdriver, 14 mm Standard tool
10 Nutdriver,
9
@
16
inch Standard tool
11 Wrench, 5 mm Standard tool
12 Wrench,
1
@
16
inch Standard tool
13 Wrench,
5
@
16
inch Standard tool
14 Needle-nose pliers Standard tool
15 Retaining ring pliers Standard tool;
1
1
@
8
inch minimum throw
16 Angle-tip tweezers Standard tool
17 Pliers Standard tool
18 Soldering iron Standard tool
19 Solder wick Standard tool
20 Adhesive TRA-CON: Tra-Bond #BA-2114