TallyGenicom 8124, User Manual

Page: 33 / 306

Setting Printer Environment
33
1
1.3
Setting the IP Address
This section describes the procedures to set the IP address.
You can set the IP address with one of the following methods.
●
Using the Quick Setup menu on the control panel.
●
Setting the IP address from the control panel.
This section describes the procedure to set the IP address from the control panel.
To set the IP address using the Quick Setup menu, refer to “Setting the Printer Environment
With the Quick Setup Menu” (P.30).
●
You can change the IP address from the Embedded Web Server. For information about Embedded Web Server,
refer to “Configuring from the Computer (Embedded Web Server)” (P.39).
●
Depending on the network environment, you may need to set the subnet mask and gateway address for the printer.
If your network has the DHCP, BOOTP, or RARP environment, this printer can obtain these addresses from each
of these servers.
●
By factory default setting, these addresses are automatically obtained from the DHCP server.
●
Use the DHCP server together with the Windows Internet Name Service (WINS) server.
●
When using the BOOTP or RARP server, change the item [Get IP Address] to [BOOTP] or [RARP] on the
control panel. Check with your system administrator for any queries on the BOOTP or RARP environment.
“Chapter 5 Setting Control Panel” (P.155)