TallyGenicom 8124, User Manual

Page: 119 / 306

119
3
Printing
3.3
Printing Non-Standard/
Long Paper Sizes
This section describes how to print non-standard paper sizes such as long paper.
The following paper sizes can be used in this printer.
●
Non-standard paper sizes of less than 135 mm on a side cannot be output to the Face Up Tray (optional).
●
Printing long paper sizes (length: 431.9 to 1200 mm) requires memory of 384 MB or more.
●
Long paper sizes cannot be printed even if [High Resolution] is selected in [Print Mode].
3.3.1
Loading Paper of Non-Standard Sizes
This section describes how to load paper of non-standard sizes.
For Tray 5 (bypass tray)
This procedure loads long-size paper into Tray 5 (bypass tray) as an example.
●
To load paper of non-standard sizes other than long-size paper, refer to “4.2.2 Loading Paper into
Tray 5 (bypass tray)” (P.153).
●
To use the Banner Tray (optional), refer to “When using the Banner Tray (optional)” (P.120).
Procedure
1
Load long-size paper in Tray 5 (bypass
tray) with the side to be printed facing
down and the end of the paper curled
as shown in the figure.
●
Curl the end of the long-size paper at the location as
far as possible from the paper supply section.
Otherwise, the curled end may be caught in the paper
supply section, resulting in creased or wrinkled
paper.
●
Load only one sheet of paper at a time.
„
For Tray 1
„
For 2 to 4
„
For Tray 5 (bypass tray)
* Except for the sizes with a short
edge less than 182 mm and a long
edge exceeding 297 mm.
* Except for the sizes with a short
edge less than 182 mm and a long
edge exceeding 297 mm.
Long edge
(horizontal): 148 to 431.8 mm
Feeding
direction
Short edge
(vertical):
182 to 297 mm
Long edge
(horizontal): 182 to 431.8 mm
Feeding
direction
Short edge
(vertical):
182 to 297 mm
Long edge (horizontal):
98 to 431.8 mm
Long paper Size:
431.9 to 1200 mm
Feeding
direction
Short edge
(vertical):
90 to 305 mm
Side to be
printed