Taiden HCS-4800 Series, Installation And Operating Manual

Page: 121 / 233

It is used for locking the units in case the delegates
leave for a short time. Delegate units will work on after
delegates sign-in again (The DCS server cannot stop
sign-in).
D. “Other” (key “5”)
Use this key to request intercom, setup LCD display
language and system information:

“Call” (key “1”)
The earphone shall be plugged to use the intercom
function. If not, it will remind you to plug the earphone.
If the current unit is using the intercom function, it will
remind you that the line is busy. Press “Call” (key “1”) to
use the intercom function, and the following interface at
the left side is displayed. When the operator approved
your request, then the following interface at the right
side is shown:

“ Setting ” (key “3”)
Press “Setting” (key “3”), and the following interface is
shown:

Press “ Language ” (key “1”) to select the LCD
display language between several languages. The
range is limited by the configuration in the CMU
(refer to section 2.1.3);

Press “ Info ” (key “3”), and the following interface is
shown:

Press “ Interpretation ” (key “1”) to run through
information about all interpretation languages:

Press “ Right ” (key “3”) to check the rights of this
unit:

Press “ About ” (key “4”) to display the product
information:
8. VIP unit

Any delegate unit can be assigned as a VIP unit by
the TAIDEN conference management system
software. At most 32 VIP units can be assigned;

As long as the active microphone capacity is not
full, the microphone of the VIP unit can be
activated freely;

If the active microphone capacity is full, the
microphone of the VIP unit cannot be turned on
unless one of the active microphones is
deactivated.
3.6.4.2 Chairman unit
The chairman unit features all the functions of a
delegate unit, and the following additional functions:
1. Priority

If the priority mode on the main unit is configured
as “All mute”, all active delegate microphones
(except VIP units) will be muted temporarily when
this key is pressed and they will restore when this
key is released;

If the priority mode on the main unit is configured
as “All off”, all active delegate microphones (except
VIP units and other chairman units) will be turned
off and the request-to-speak list will be purged
(under “Open” and “Request” mode) when this key
is pressed
2. Speaking

If the active microphone capacity is not full, the
chairman can activate his/her microphone normally,
the operation is the same as for the delegate unit;
108