6. Adjust the camera angle by the four direction buttons, and click zoom in/out button to adjust the size of the video
image;
7. Click “Save and Send to MU” button to save the current predefined position if the adjustment is done;
8. If you need to modify position, please click “Delete” and then set the new position again; click “Predefine Position
Management” to delete part or all positions;
9. If needed, please set position 2 number, methods refer to position1 number;
10. Repeat steps 2~9 to set the predefined position for other seats/microphones.
Each unit can be set with two predefine positions, the two predefine positions must be saved in two cameras but the two
cameras must be connected to the same matrix. If “Synchro” selected, when you switch positions between position1 and
position2, the picture switches synchronously.
During the conference, if all microphones are configured with predefined positions, the camera will aim at the speaking
participator automatically, i.e. automatic video tracking.
Note:
If “Auto Iris” option is checked, predefined positions use auto iris; if not checked, the predefined positions can be
adjusted manually (RS-232).
Booth parameter
Set up the booth parameter.
1.Distribute floor to unused SI CH: change the floor for unused SI CH automatic;
2.Listener Count:Display listener number of corresponding output lanaguge;
3.Auto Distrubuter Floor :If the interpreter select an input channel is same to the intepreter station output channel, it will
switch to the floor input;
4.
Allows switching output channel when microphone is active: when microphone is active, allowing switch output
language channel;
5.Interp Unit Mic. Gain Boost: 0dB, +3dB, +6dB;
6. 2 Letters Abbc. Display 2 letters abbreviation of lanaguage on operation interface;
7. Display Speech Time: LCD screen display open time of the microphone, which is convenient for the interpreter hourly
wage account;
8. Enable Interp. Noice Gate: Set up whether enable the Interpreter noice gate or not;
9.Booth Interlock mode: Set up the booth interlock mode(interlock between the interpreter pattern: set an interpreter
between channel interlock pattern (interlock/take/grab - BC), under the BC mode, A channel cannot be preempted, but A
41
Summary of Contents for HCS-4800 Series
