Taiden HCS-4800 Series, Installation And Operating Manual

Page: 25 / 233

Figure 2.1.5 CMU connecting to contribution units
(RJ45)
For a longer distance between the contribution unit and
the CMU/EMU, a Cat5e cable can be used. One end of
the Cat5e cable is connected to output of the main unit
via the CBL8P2RJ45S converter cable; the other end
of the Cat5e cable is connected to the contribution unit.
Figure 2.1.6 CMU connecting to contribution units
(RJ45)
For “Closed Loop - Daisy Chain” ring connection,
HCS-8600MCLS Loop switcher is needed. The "TO
MU" port of HCS-8600MCLS is connected to the output
of the main unit via CBL8P2RJ45 converter cable; the
other port of HCS-8600MCLS is connected to the
contribution unit; at last, connect the last contribution
unit back to the CMU via a CBL8P2RJ45S converter
cable.
Figure 2.1.7 “Closed Loop - Daisy Chain” connection
topology (RJ45)
In HCS-4800 series fully digital congress system,
power is provided by HCS-4800M CMU (or HCS-8600
EMU) for all congress units. Since the power capacity
of a 8P-DIN interface is limited, it must be ensured that,
during the installation, the sum of the total power
consumption of all the congress units connected to
every single 8P-DIN interface plus the power loss in the
extension cables does not surpass the power limit of
each 6P-DIN interface. Otherwise the system will not
work properly or automatic protection will occur. (refer
to section 5.1.1 connection principles).
2.1.2.2 To sound equipment
The CMU of the HCS-4800 system has a pair of RCA
symmetrical audio outputs “LINE OUT 2” and a 3-cord
XLR balanced output “LINE OUT 1”, to be connected to
a PA. Connecting the RCA symmetrical audio outputs
or the 3-cord XLR balanced output of the CMU to the
input port of the PA via an audio wire.
Figure 2.1.8 CMU connecting to PA
13