Taiden HCS-4800 Series, Installation And Operating Manual

Page: 97 / 233

Figure 3.5.1:
1. Stem microphone socket
2. Priority key with indicating light (for the
chairman unit only):

According to the priority mode configuration on the
main unit:
a) If configured as “All mute”, all active delegate
microphones (except VIP units) will be muted
temporarily when this key is pressed and they
will resume when the key is released;
b) If configured as “All off”, all active delegate
microphones (except VIP units) will be switched
off when this key is pressed. Under “Open” and
“Request” mode, pressing this key will clear the
request list (deny all delegates’ requests to
speak);

If the chairman microphone is not active, pressing
this key will activate it.
3. Microphone On/Off key with indicating light (for
the chairman unit)
Microphone On/Off/request key with indicating
light (for the delegate unit):

Chairman unit: press this key to activate/deactivate
the microphone;

Delegate unit: press this key to activate/deactivate
the microphone or request/cancel request to
speak.
Work state Indicating light
Microphone On Red (on)
Speaking time limit Red (flash)
Request speaking Green (on)
VIP indication Yellow (on)
4. Earphone jack (Ø 3.5 mm)
5. Simultaneous interpretation channel selector

Available when earphone is plugged.
6. OLED screen

Display SI channel language and earphone
volume.
7. Earphone volume control
8. Multi-function keys with indicating light (3 keys):

In different modes, the corresponding indicating
lights blink; press the corresponding key to
execute operation (refer to table 3.5.1 for details).
9. Contactless IC Card slot

Built-in contactless IC-Card slot to place the IC
card, while automatically logout once the card is
taken out from the slot.
10. Multi-function keys with indicating light (5
keys):

In different modes, the corresponding indicating
lights blink; press the corresponding key to
execute operation (refer to table 3.5.2 for details).
11. Loudspeaker
12. Loudspeaker jack (Ø 3.5 mm)
13. Standard RJ11 socket

Connecting to HCS-48U6DVOT.
14&15. 2 × RJ45 socket

For daisy chain connection;

Recommended to use of cat5e cable with a drain
wire & RJ45 plug with metal shield, and connect to
main unit via CBL8P2RJ45S converter cable.
16. Standard RJ11 socket

Connecting to HCS-48U6SELM/80.
17. 3P socket

Connecting to the microphone LED ring signal of
HCS-48U6MICS.
18. 2P socket

Connecting to the microphone signal of
HCS-48U6MICS.
19. Standard RJ11 socket

Connecting to HCS-48U6MICS.
20. Standard RJ11 socket

Connecting to HCS-48U6MICM/80 or HCS
48U6SELM/80.
84