Suzhou MONARCH Control Technology Co., Ltd. NICE3000 New, User Manual, Page: 203 / 233

NICE3000
new
User Manual Description of Function Codes
- 201 -
to exit the leveling adjustment state. Then, car calls can be registered.
21. Press the door close button, and press the button for the next floor. The elevator runs
to the next floor and keeps the door open after arrival. Then, you can perform leveling
adjustment.
22. After completing adjustment for all floors, set Fr-00 to 0 to disable the leveling
adjustment function. Otherwise, the elevator cannot be used.
Pay attention to the following precautions during the operation:
1. Each time shaft auto-tuning is performed, all leveling adjustment parameters can be
cleared or reserved.
a. If you set F1-11 to 3 on the operator or F7 to 1 on the keypad, all leveling
adjustment parameters are reserved.
b. If you set F1-11 to 4 on the operator or F-7 to 2 on the keypad, all leveling
adjustment parameters are reserved.
2. When the re-leveling function is used, the leveling adjustment function is automatically
shielded and cannot be used.
Group FF: Factory Parameters
Group FP: User Parameters
Function Code Parameter Name Setting Range Default Unit Property
FP-00 User password 0–65535 0 -
☆
It is used to set the user password.
If it is set to any non-zero number, the password protection function is enabled. After a
password has been set and taken effect, you must enter the correct password in order to
enter the menu. If the entered password is incorrect, you cannot view or modify parameters.
If FP-00 is set to 00000, the previously set user password is cleared, and the password
protection function is disabled.
Remember the password that you set. If the password is set incorrectly or forgotten, contact
Monarch to replace the control board.
Function Code Parameter Name Setting Range Default Unit Property
FP-01 Parameter update 0–2 0 -
★
It is used to set processing on the parameters.
The values are as follows:
• 0: No operation
• 1: Restore default settings
• 2: Clear fault records
If you set this parameter to 1 (Restore default settings), all parameters except group F1 are