Suzhou MONARCH Control Technology Co., Ltd. NICE3000 New, User Manual, Page: 174 / 233

Description of Function Codes NICE3000
new
User Manual
- 172 -
Function Code Parameter Name Setting Range Default Unit Property
F7-04 Hall call enabled
0: Yes
1: No
0 -
☆
It is used to enable the hall call function.
• 0: Yes (hall call allowed)
• 1: No (hall call forbidden)
Function Code Parameter Name Setting Range Default Unit Property
F7-05 Door open enabled
0: Yes
1: No
0 -
☆
It is used to enable the door open function.
• 0: Yes (door open allowed)
• 1: No (door open forbidden)
Note
Continuous running of the elevator without opening the door accelerates overheating of the
controller module. Long-time use in such mode may cause overheat protection, and therefore, use
the function with caution.
Function Code Parameter Name Setting Range Default Unit Property
F7-06 Overload function
0: Disabled
1: Enabled
0 -
☆
It is used to enable the overload function.
Note
This function is used only in the heavy-load test. Once the test is complete, prohibit over-load
running immediately.
Function Code Parameter Name Setting Range Default Unit Property
F7-07 Limit switch
0: Enabled
1: Disabled
0 -
☆
It is used to enable the limit switch function.
Note
The limit switch is disabled only in the test of the final limit switch. Use the function with caution.
Function Code Parameter Name Setting Range Default Unit Property
F7-08 Time interval of random running 0–1000 0 s
☆
It is used to set the time interval between two times of random running.