Supermicro SuperBlade SBM-GEM-X2C+, User Manual

Page: 55 / 404

3-3
Chapter 3: Setup and Installation
5. Push the release handle to the closed position.
Removing a Switch Module
1. Pull out the release handle to the open position.
2. Pull the module out of the bay.
3. Replace immediately with another module or with a dummy module cover to
maintain airflow integrity.
Figure 3-2. Blade Enclosure with 1/10-Gbps Switch Modules Installed
NOTE: After the module has been installed and the handle locked, it will turn on
and a POST test will run to verify it is working properly. If there are no problems
the blue
Init. OK LED on the module will illuminate and you will see an OK
under I
NITIATED
in the G
B
E S
WITCH
screen of the management software utility.
NOTE: If the module is installed in a top bay it must be positioned upside-down.
SBM-GEM-X2C(+)
Switch
SBM-XEM-002M Pass-Through Module