Supermicro SuperBlade SBM-GEM-X2C+, User Manual

Page: 281 / 404

7-153
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Route Aggregations
Clicking the R
OUTE
A
GGR
tab brings up the BGP R
OUTE
A
GGREGATION
C
ONFIGURATION
page ( Figure 7-134 ), which is used to aggregate and configure the routes advertised by
BGP. The parameters for this page are shown in Table 7-107 .
Figure 7-134. BGP Route Aggregation Configuration Page
Table 7-107. BGP Route Aggregation Configuration Page Parameters
Parameter Description
ID This parameter specifies the index to this table.
IP Address Prefix
This parameter specifies the IP address prefix that needs to be
aggregated.
IP Address Prefix Length
This parameter, in combination with the IP Prefix, decides the aggregated
route to be distributed by this switch.
Route Advertise
With this parameter you can either choose to advertise only the
aggregated routes by setting
Summary only, or choose to advertise all
routes by setting All .
Status This parameter specifies the status of the entry.