155
Function No. : 087
Function Name: Set reverse rotation angles after trimming [SPS/B/C-Series]
The function is to set reverse rotation angles during reverse rotation operation of machine.
It is available to set reverse rotation angles. (Factory installed condition:
"
15
°
°
"
)
[Contents] It is possible to set reverse rotation angle. The reverse rotation angle, set when
reverse rotation after trimming mentioned in Function No.: 76 is set at ENABLE, will be
applied.
087. ReverseAngle
1
。
~40
。
Setting
Value
Function No. : 088
Function name: Oil control (SPS/C/S-Series)
Set up a time for hook lubrication after trimming.
Set up oil control time (Set-up value at the factory: "4")
[Contents] This function is designed to supply oil to the hook after trimming for a set period of
time, using pneumatic pressure. The unit of programmed set-up value is 25ms, and
the set-up value at the time of the factory release is 4, or 0.1 seconds (25*4=100ms).
Set the value at "0" when the function is not used.
088. Oil Control
0
。
~10
。
Setting
Value
Function No. : 089
Function name: Oil spray cycle off-time setting (C-Series model)
It sets the oil spray cycle off-time.
The off-time of oil spraying cycle can be set (default value: 5).
[Contents] To prevent dust and thread scraps from sticking to the hook, oil is sprayed into the
hook. The spraying frequency is set at "091. Oil Control."
089. OilOffTime
00~50[ms]
Setting
Value
"092. Oil Off Time" set value
"091. Oil Control On Time" set value
