43
3-1) Operation after reading pattern data from USB flash drive and moving the second temporary start point
It is possible to move to the sewing start point or the second origin by using direction keys in the sewing
available state. To decide the moving point, whether it is the sewing start point or the second origin, set
up 1) PNT_STR_POS or 2) SECND_ORG at the general sewing related parameter No. “001. Move to
starting point/the second origin manually.”
※ Note : It is available when READY LED turns on, and this function is used for movement to the
temporary sewing start point or the second origin. By setting up the second origin within
pattern data, the same position can be set up as the second origin.
A. Insert a USB flash drive into the terminal.
B. Press NO key, then input the pattern number
by using digit keys. (If you want to work with
“001”pattern, input [0][0][1].)
C. Press ENTER
key to read a pattern and to
change to sewing available mode.
D. The upper feed plate comes to descend and
moves to the origin or sewing start point then
ascends. READY LED lights up.
E. Press SPEED key to adjust speed properly.
F. If you step on the pedal switch on the right side,
the upper feed plate comes to descend.
G. After moving to a random second origin by
using direction keys, if you step on the pedal
switch on the left side, the machine moves to
the sewing start point or the second origin and
starts relevant works. At this time, be careful
not to exceed the transfer limit of feed plate.
H. If the work is finished, a needle moves to the
origin or the sewing start point and the upper
feed plate comes to ascend. If you want to
back to the initial sewing start point or the first
origin, press ENTER
key to read the pattern
to work one more time.
N O : 0 0 1 N O R _ S E W
X S : 1 0 0 %
Y S : 1 0 0 % S P : 2 0 0 0
B C : 0 0 0 P C : 0 0 0 0
N O : 0 0 1 N O R _ S E W
X S : 1 0 0 %
Y S : 1 0 0 % S P : 1 5 0 0
B C : 0 0 0 P C : 0 0 0 0
3) Pattern Data Application Function
Y
X
(0,0)
(-650,-300)
(650,300)
