193
Before use, some parameters should be set up. The setting details are as follows:
(Except for the barcode setting function, it is same to the existing AutoCall function.)
< < M a i n M e n u > >
1 . P a r a m e t e r S e t
2 . P r o g r a m
3 . B o b b i n W i n d
< P a r a m e t e r S e t >
0 9 7 . A u t o C a l l
0 9 8 . A u t o R e a d y
0 9 9 . A t t a c h S e t
0 9 7 . A u t o C a l l
1 ) D I S A B L E
2 ) E N A B L E
3 ) B A R C O D E < -
NO : 001 BARCODE
XS : 100%
YS : 100% SP:2500
BC : 014 PC:0058
A. Press the MODE key on the initial screen and select
Parameter Set on the Main Menu.
The following is related to setting parameters for design
auto call.
The parameters below needed to be set.
097. Auto Call : Sets automatic design call using
barcodes.
098. Auto Ready : Sets automatic sewing ready status
after design call.
099. Attach Set : Sets enable or disable of sewing start,
clamp, and enter key.
100. AutoCall TM : Sets the lapse time of input sensor
upon design auto call. (This
function is meaningless in the
barcode system.)
B. Select 097. Auto Call, and move the cursor to BARCODE.
Press the enter key to save the value.
C. Set 098, 099 depending on situations.
D. When the sewing returns to the initial mode, user
can check that
“
NOR_SEW
”
is changed to
“
BARCODE
”
.
E. If a barcode device is used and barcode labels are
scanned, the design numbers are automatically
converted. As such, designs can be automatically
read.
Reference) When the barcode-based auto call
function is used, if user uses the pedal
and enter key manually as of in the
regular sewing mode (NOR_SEW), the
motions activated by the pedal and enter
key might be a bit delayed.
