49
< < M a i n M e n u > >
2 . P r o g r a m
3 . B o b b i n W i n d
4 . M a c h i n e T e s t
M. Complete the program for the rest part of the
square by using LINE.
N. After performing test sewing, store the programmed
pattern with new number.
O. To complete pattern creation, press MODE key.
The upper feed plate moves up after returned to
the origin. Return to the initial screen by pressing
ESC key.
3-3) Program Example 6 : Use of Reversal
It is used when reversal devices is available. Careful attention must be paid to that reversal pressure plate
or reversal cylinder drive part is not to be interfered with needle bar when programming the pattern.
There are two ways to input the code for reversal (an order to drive the reversal devices), one is to add
only code for reversal after calling the already programmed pattern, and the other is to program newly.
3-3-1) Pattern Programming by Using Reversal
A. Insert a USB flash drive into the terminal.
B. Press MODE key.
C. By using direction keys
, move to “2.
Program”menu, then press ENTER
key.
At this time the upper feed plate descends, and
moves to the origin.
< < M a i n M e n u > >
2 . P r o g r a m
3 . B o b b i n W i n d
4 . M a c h i n e T e s t
O R I G I N
X : 0 0 0 0 0 A N : 0 0 0 9 9
Y : 0 0 0 0 0 A
F u n c t i o n C o d e ?
JUMP
P2
P3
P4
P5
P6
(0,0)
B
A
End
P1
Beginning of Program
Beginning of Sew
Turn on the Reverse Cylinder
